Short answer: Order the plant for the exact voltage and frequency at your site. A 50 Hz motor on 60 Hz runs about 20% faster and a 60 Hz motor on 50 Hz runs about 17% slower, so fans, pumps and conveyors stop behaving as designed. A transformer changes voltage but not frequency, and on generator power the plant and generator are specified together.
An asphalt plant has dozens of motors, plus heaters, sensors and a control system — all built for one voltage and one frequency. Ordering the wrong electrical system is one of the costliest mistakes in an export purchase.
What happens with the wrong frequency
| Situation | Effect |
|---|---|
| 50 Hz motor on 60 Hz supply | Runs about 20% faster: fans and pumps overload; conveyors and feeders run too fast; drives stressed |
| 60 Hz motor on 50 Hz supply | Runs about 17% slower: output falls; motors may overheat at reduced cooling |
| Wrong voltage | Overheating, failure to start, damage to electronics |
Which frequency where (examples)
| 50 Hz | 60 Hz |
|---|---|
| Most of Africa, Europe, the Middle East (except Saudi Arabia), South and Central Asia, China, Indonesia, Vietnam, Malaysia, Thailand, Australia | Most of the Americas (including Peru, Colombia, Mexico, Brazil, USA), the Philippines, Saudi Arabia, South Korea, Taiwan, parts of Japan |
Some countries have mixed systems or exceptions. Always confirm the exact supply at your site — and in Latin America, check by country (for example Peru is 60 Hz, while Chile and Argentina are 50 Hz).
Typical industrial voltages
| Supply | Examples of where it is common |
|---|---|
| 380–415 V, 50 Hz, three-phase | Much of Asia, Africa, Europe |
| 440–480 V, 60 Hz, three-phase | Parts of the Americas, some industrial sites elsewhere |
| 220 V or 380 V, 60 Hz | Some Latin American networks |
| Medium voltage via transformer | Large plants with their own substation |
What to tell your supplier
- Voltage and frequency at the site
- Grid capacity available, or generator power
- Any voltage instability or frequent outages
- Whether the plant may later move to a country with a different supply
If the plant will move between 50 Hz and 60 Hz countries, discuss variable frequency drives and dual-rated equipment at the order stage.
Generators
On generator power, specify the generator for the plant’s voltage and frequency, and size it for starting loads — see the generator size calculator. At altitude, derate the generator — see high-altitude configuration.
Country examples
The Philippines and Peru are 60 Hz; Indonesia, Nigeria, Kenya and Uzbekistan are 50 Hz.
Source
Mains electricity by country. Confirm with your utility or site electrician.



